Basement Systems Vancouver Before & After Photos

To create a cleaner, drier, and more energy-efficient crawl space, we’ll begin by removing debris and installing a durable encapsulation system. The liner will securely seal around footings, piers, and foundation walls. If insulation is present, the liner will extend slightly over it for a tight seal. A drainage mat will be added to manage moisture and improve durability. Insulated wall panels will be installed with sealed seams to prevent moisture and odors. Lastly, we’ll spread drain rock for added protection and install wire mesh over openings.

This project focused on permanently stopping water from entering through a foundation crack. Small ports were installed along the crack, and a flexible resin was injected under pressure to fully seal it from the inside. Once sealed, the ports were removed, and the surface was finished neatly with fast-setting cement.

The repair was then flood-tested from the outside to ensure it was completely watertight. The area was cleaned, vacuumed, and any insulation that had been removed was reinstalled as needed.

This repair helps prevent future leaks, protects the foundation, and comes with a 24-month warranty for added peace of mind.

A damp crawl space can lead to musty odors, mould, and even structural issues. That’s why we fully seal and protect the area by securely fastening and air-sealing a durable moisture barrier at footings, piers, and foundation walls. If insulation is present, the barrier extends 6” in front of it for complete coverage.

To further protect your home, we add a drainage layer beneath the barrier, extending slightly up the exterior walls. This prevents ground seepage, improves durability, and creates a cleaner, healthier space & perfect for storage and peace of mind.

Installed a Smart Sump Pump system with battery backup

To stop water from leaking through the ceiling, we drilled small holes and injected a waterproof material into the cracks under high pressure. Once the cracks were fully sealed, we removed the injection points and cleaned up the area. Finally, we patched the surface with fast-drying cement to leave it neat and smooth.